Netgear DGN2200M 사용자 설명서
Advanced Configuration
93
N300 Wireless ADSL2+ Modem Router DGN2200M Mobile Edition
Multi-Point Bridge
Multi-point bridge mode allows a router to bridge to multiple peer access points
simultaneously. Wireless client associations are disabled. Only wired clients can be
connected. Multi-point bridge mode configuration includes the following steps:
simultaneously. Wireless client associations are disabled. Only wired clients can be
connected. Multi-point bridge mode configuration includes the following steps:
1.
Enter the MAC addresses of the other access points in the fields provided.
2.
Set the other bridge-mode access points to point-to-point bridge mode, using the MAC
address of this DGN2200M Mobile Edition as the remote MAC address.
address of this DGN2200M Mobile Edition as the remote MAC address.
3.
Use wireless security to protect this traffic.
Internet
LAN Segment 1
Computers
Computers
Hub or switch
AP 3
AP 2
192.168.0.1
Point-to-point
bridge mode
bridge mode
Point-to-point
AP 1
DGN2200M
Computers
Hub or switch
LAN Segment 3
LAN Segment 2
Figure 2. Multi-point bridge mode
To set up the multi-point bridge configuration:
1.
Configure the operating mode of the wireless modem routers.
•
Because it is in a central location, configure the DGN2200M Mobile Edition wireless
modem router (AP 1) on LAN segment 1 in point-to-multi-point bridge mode, and
enter the MAC addresses of AP 2 and AP 3 in the Remote MAC Address 1 and
Remote MAC Address 2 fields.
enter the MAC addresses of AP 2 and AP 3 in the Remote MAC Address 1 and
Remote MAC Address 2 fields.
•
Configure the access point (AP 2) on LAN segment 2 in point-to-point bridge mode
with the remote MAC address of the DGN2200M Mobile Edition wireless modem
router.
router.
•
Configure the access point (AP 3) on LAN segment 3 in point-to-point bridge mode
with the remote MAC address of the DGN2200M Mobile Edition wireless modem
router.
router.
2.
Disable the DHCP server on AP 2 and AP 3. AP 1 will then be the DHCP server.
3.
Verify the following for all access points: