Netgear DGND3700 사용자 가이드

other bridge-mode wireless station in the field provided. Use wireless security to protect this 
communication. The following figure shows an example of point-to-point bridge mode.

 

 

LAN Segment 1

PC’s

PC’s

LAN Segment 2

Switch or hub

AP 2

Both access points (APs) are in

Internet

AP 1 (DGND3700 modem router)

point-to-point bridge mode.

192.168.0.1



Configure the DGND3700 wireless modem router (AP 1) on LAN Segment 1 in 
point-to-point bridge mode.

Configure the other access point (AP 2) on LAN Segment 2 in point-to-point bridge mode. 

The DGND3700 wireless modem router has to have AP 2’s MAC address in its Remote 
MAC Address field, and AP 2 has to have the DGND3700’s MAC address in its Remote 
MAC Address field. 

Configure both APs and verify that both APs are using the same SSID, channel, 
authentication mode, if any, and security settings if security is in use.

Disable the DHCP server on AP 2. AP 1 will then be the DHCP server.

Verify connectivity across LAN Segment 1 and LAN Segment 2. A computer on either LAN 
segment should be able to connect to the Internet or share files and printers of any other 
PCs or servers connected to LAN Segment 1 or LAN Segment 2.

Multi-Point Bridge 

Multi-point bridge mode allows a router to bridge to multiple peer access points 
simultaneously. Wireless client associations are disabled. Only wired clients can be 
connected. Multi-point bridge mode configuration includes the following steps:

Enter the MAC addresses of the other access points in the fields provided. 

Set the other bridge-mode access points to point-to-point bridge mode, using the MAC 

address of this DGND3700 as the remote MAC address. 

Use wireless security to protect this traffic.