Netgear DGND3700 사용자 가이드

Test the LAN Path to Your Wireless Modem Router

You can ping the router from your computer to verify that the LAN path to your router is set up 
correctly.



From the Windows task bar, click the Start button, and select Run.

In the field provided, type ping followed by the IP address of the router, as in this example:

Click OK.

You should see a message like this one:

Pinging <IP address> with 32 bytes of data

If the path is working, you see this message:

Reply from < IP address >: bytes=32 time=NN ms TTL=xxx

If the path is not working, you see this message:

Request timed out

If the path is not functioning correctly, you could have one of the following problems:

Wrong physical connections

Make sure that the LAN port LED is on. If the LED is off, follow the instructions in 

Check that the corresponding link LEDs are on for your network interface card 

and for the hub ports (if any) that are connected to your workstation and router.

Wrong network configuration

Verify that the Ethernet card driver software and TCP/IP software are both 

installed and configured on your PC or workstation.

Verify that the IP address for your router and your workstation are correct and that 

the addresses are on the same subnet.