Netgear WGX102 참조 매뉴얼

Preparing Your Network

C-1

This appendix describes how to prepare your network to connect to the Internet through the 54 
Mbps Wall-Plugged Wireless Range Extender WGX102 and how to verify the readiness of 
broadband Internet service from an Internet service provider (ISP).

You need to prepare these three things before you begin:

To use the WGX102 Wall-Plugged Range Extender on your network, each computer must have an 
802.11g or 802.11b wireless adapter or an installed Ethernet Network Interface Card (NIC) and an 
Ethernet cable. If the computer will connect to your network using an Ethernet NIC at 100 Mbps, 
you must use a Category 5 (Cat 5) cable such as the one provided with your router. For an 
explanation of Ethernet cabling, see 

. The cable or DSL 

broadband modem must provide a standard 10 Mbps (10BASE-T) or 100 Mbps (100BASE-Tx) 
Ethernet interface.

Note: If an ISP technician configured your computer during the installation of a 
broadband modem, or if you configured it using instructions provided by your ISP, you 
may need to copy the current configuration information for use in the configuration of 
your firewall. Write down this information before reconfiguring your computers. Refer 
to 

” on 

 for 

further information.