Netgear WGX102 참조 매뉴얼

8-16

Advanced Configuration of the WGX102

•

A Metric value of 1 will work since the ISDN router is on the LAN. 

•

Private is selected only as a precautionary security measure in case RIP is activated.

Using the Remote Management page, you can allow a user or users on the Internet to configure, 
upgrade and check the status of your WGX102 Wall-Plugged Range Extender.

To configure your range extender for Remote Management:

1. Select the Turn Remote Management On check box.

2. Specify what external addresses are allowed to access the range extender’s remote 

management.

 

 
Note: For enhanced security, restrict access to as few external IP addresses as practical.

a.

To allow access from any IP address on the Internet, select Everyone. 

b.

To allow access from a range of IP addresses on the Internet, select IP address range.

 

Enter a beginning and ending IP address to define the allowed range. 

c.

To allow access from a single IP address on the Internet, select Only this computer.

 

Enter the IP address that is allowed access. 

3. Specify the Port Number to use for accessing the management interface.

Web browser access normally uses the standard HTTP service port 80. For greater security, 
change the remote management Web interface to a custom port by entering that number in the 
box provided. Choose a number between 1024 and 65535, but do not use the number of any 
common service port. The default is 8080, which is a common alternate for HTTP.

4. Click Apply to have your changes take effect.

Note: Be sure to change the range extender's default configuration password to a very 
secure password. The ideal password should contain no dictionary words from any 
language, and should be a mixture of letters (both upper and lower case), numbers, and 
symbols. Your password can be up to 30 characters.