Quantum DLT-S4 사용자 가이드
Chapter 9 Installing an Internal SCSI Tape Drive
Securing the Tape Drive in the System
DLT-S4 Product Manual
71
Securing the Tape Drive in the System
9
This section describes how to mount and secure the tape drive in the
system. Because of the variety of mounting possibilities for tape drives,
the instructions presented here are general guidelines. Use these
instructions only as a guide for mounting the tape drive in the system.
Mount the tape drive in the system by performing the following steps:
1
Ensure that the host computer and all peripheral devices are turned
off.
2
Position the tape drive in the system and align the tape drive
mounting holes (side or bottom) with those in the system (see
3
Secure the tape drive in the bay or chassis using four M3 x 8mm long
screws.
Note:
The computer system and the tape drive SCSI IDs are only
checked when you turn both the computer system and the
tape drive off and then on again. To change the SCSI ID after
installation, turn off the system, change the tape drive’s SCSI
ID, and then turn on the system.
Note:
In some system configurations, it may be more convenient to
connect the SCSI bus and power cables to the tape drive before
securing it in the system.
Caution:
The screws used to mount the tape drive must be
M3 x 8mm long. This kind of screw is exactly the
proper length and will not damage the tape drive.