Mitsubishi 56p-qf60lcu 사용자 설명서
EN-4
WARNING:
Unplug immediately if there is something wrong with
your product.
Unplug immediately if there is something wrong with
your product.
Do not operate if smoke, strange noise or odor comes out of
your product. It might cause fi re or electric shock. In this case,
unplug immediately and contact your dealer.
your product. It might cause fi re or electric shock. In this case,
unplug immediately and contact your dealer.
Never remove the cabinet.
This product contains high voltage circuitry. An inadvertent
contact may result in an electric shock. Except as specifi cally
explained in the Owner’s Guide, do not attempt to service this
product yourself. Please contact your dealer when you want to
fi x, adjust or inspect the product.
contact may result in an electric shock. Except as specifi cally
explained in the Owner’s Guide, do not attempt to service this
product yourself. Please contact your dealer when you want to
fi x, adjust or inspect the product.
Do not modify this equipment.
It can lead to fi re or electric shock.
Use the optional specifi ed power supply cord.
This apparatus must be grounded.
Place the product more than 5 cm (2 in.) from the
wall to prevent blocking the intake, exhaust slots and
ventilation of this product because hot air comes out
of it.
Carry the product by all four handles, not by two
handles.
Do not use the product under the following circum-
stances, which may cause fi re or electric shock.
This apparatus must be grounded.
Place the product more than 5 cm (2 in.) from the
wall to prevent blocking the intake, exhaust slots and
ventilation of this product because hot air comes out
of it.
Carry the product by all four handles, not by two
handles.
Do not use the product under the following circum-
stances, which may cause fi re or electric shock.
• in a dusty or humid place
• near a heater
• in a oily, smoky or damp place
• in direct sunlight
• with high temperature, such as the closed car
• where the temperature is lower than 5°C (41°F) or higher
• near a heater
• in a oily, smoky or damp place
• in direct sunlight
• with high temperature, such as the closed car
• where the temperature is lower than 5°C (41°F) or higher
than 35°C (95°F)
CAUTION:
Battery replacement of the optional remote control
Battery replacement of the optional remote control
• Improper use may result in fi re, injury, or spread dirt due to
leakage, heat generation, or explosion.
• Replace all the batteries with new ones. Use two AAA
batteries (R03).
• Load the batteries with their (+) and (-) sides correctly.
• Load the batteries from (-) sides fi rst.
• Load the batteries from (-) sides fi rst.
For the LAN terminal;, use an Ethernet cable only.
For your safety, connect to an Ethernet network which does not
exceed the voltage limit of the Ethernet connector.
exceed the voltage limit of the Ethernet connector.
Use “CAT5 STP (Shielded twisted pair) Ethernet ca-
ble” for control.
ble” for control.
If you use unshielded control cable, it may cause interference
with radio and television reception.
with radio and television reception.
Recommended Use
• For optimum performance, allow 30 minutes for warm-up.
• Rest your eyes periodically by focusing on an object at least
• Rest your eyes periodically by focusing on an object at least
5 feet away. Blink often.
• Clean the monitor surface with a lint-free, nonabrasive cloth.
Avoid using any cleaning solution or glass cleaner!
NOTE:
This product contains a Lithium Battery which contains
Perchlorate Material - special handling may apply, See
www.dtsc.ca.gov/HazardousWaste/perchlorate/
This product contains a Lithium Battery which contains
Perchlorate Material - special handling may apply, See
www.dtsc.ca.gov/HazardousWaste/perchlorate/
This symbol mark is for EU countries only.
This symbol mark is according to the directive
2002/96/EC Article 10 Information for users and
Annex IV.
This symbol mark is according to the directive
2002/96/EC Article 10 Information for users and
Annex IV.
Your MITSUBISHI ELECTRIC product is designed and
manufactured with high quality materials and components which
can be recycled and reused.
This symbol means that electrical and electronic equipment,
at their end-of-life, should be disposed of separately from your
household waste.
Please, dispose of this equipment at your local community
waste collection/recycling centre.
In the European Union there are separate collection systems for
used electrical and electronic product.
Please, help us to conserve the environment we live in!
manufactured with high quality materials and components which
can be recycled and reused.
This symbol means that electrical and electronic equipment,
at their end-of-life, should be disposed of separately from your
household waste.
Please, dispose of this equipment at your local community
waste collection/recycling centre.
In the European Union there are separate collection systems for
used electrical and electronic product.
Please, help us to conserve the environment we live in!
Image persistence
• Please be aware that LCD Technology may experience a phenomenon known as Image Persistence. Image Persistence occurs
when a residual or “ghost” image of a previous image remains visible on the screen. Unlike CRT monitors, LCD monitors’ im-
age persistence is not permanent, but constant images being displayed for a long period of time should be avoided. To alleviate
image persistence, turn off the monitor for as long as the previous image was displayed. For example, if an image was on the
monitor for one hour and a residual image remains, the monitor should be turned off for one hour to erase the image.
age persistence is not permanent, but constant images being displayed for a long period of time should be avoided. To alleviate
image persistence, turn off the monitor for as long as the previous image was displayed. For example, if an image was on the
monitor for one hour and a residual image remains, the monitor should be turned off for one hour to erase the image.