Sony str-da5200es 사용자 가이드
133
GB
A
d
ditio
n
al Inf
o
rm
ati
o
o
n
• Make sure you select the correct input on
the remote.
• When you operate a programmed non-
Sony component, the remote may not
function properly depending on the model
and the maker of the component.
function properly depending on the model
and the maker of the component.
Error messages
If there is a malfunction, the display shows a
code of two numbers and a message. You can
check the condition of the system by the
message. Refer to the following table to solve
the problem. If any problem persists, consult
your nearest Sony dealer.
code of two numbers and a message. You can
check the condition of the system by the
message. Refer to the following table to solve
the problem. If any problem persists, consult
your nearest Sony dealer.
PROTECTOR
Irregular current is output from the speakers
or the USB device, or the upper panel of the
receiver is covered with something. The
receiver will automatically turn off after a
few seconds. Check the speakers or the USB
device connection and turn on the power
again.
or the USB device, or the upper panel of the
receiver is covered with something. The
receiver will automatically turn off after a
few seconds. Check the speakers or the USB
device connection and turn on the power
again.
Reference sections for clearing
the memory
the memory
Specifications
AUDIO POWER
SPECIFICATIONS
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 120 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 120 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
POWER OUTPUT
Rated Power Output at Stereo Mode
Rated Power Output at Stereo Mode
1) 2)
(8 ohms 20 Hz – 20 kHz,
THD 0.09%):
120 W + 120 W
THD 0.09%):
120 W + 120 W
Reference Power Output at Stereo Mode
(4 ohms 20 Hz – 20 kHz,
THD 0.15%):
120 W + 120 W
THD 0.15%):
120 W + 120 W
Reference Power Output
(8 ohms 1 kHz, THD 0.7%)
FRONT
FRONT
2)
:
130 W + 130 W
CENTER
CENTER
2)
: 130 W
SURROUND
2)
:
130 W + 130 W
SURROUND BACK
SURROUND BACK
2)
:
130 W + 130 W
Reference Power Output
(4 ohms 1 kHz, THD 0.7%)
FRONT
FRONT
2)
:
130 W + 130 W
CENTER
CENTER
2)
: 130 W
SURROUND
2)
:
130 W + 130 W
SURROUND BACK
SURROUND BACK
2)
:
130 W + 130 W
1)
Depending on the sound field settings and the
source, there may be no sound output.
source, there may be no sound output.
2)
Measured under the following conditions:
Power requirements: 120 V AC, 60 Hz
Power requirements: 120 V AC, 60 Hz
To clear
See
All memorized settings
continued