Sony STR-DH810 사용자 가이드

The receiver is equipped with a function for converting video signals.
Video signals and component video signals can be output as HDMI video signals (HDMI TV OUT 
jack only).

: Same type of signal as that of the input signal is output.
: Video signals are upconverted and output.

As the initial setting, video signals input from the connected component are output as shown in the 
table above. We recommend you set the video conversion function to match the resolution of the 
monitor you are using. For details, see “RESOLUTION” (page 83).

• When video signals from a VCR, etc., are 

converted on this receiver and then output to 
your TV, depending on the status of the 
video signal output, the image on the TV 
screen may appear distorted horizontally or 
no image may be output.

• When you play a VCR with an image 

improvement circuit, such as TBC, the 
images may be distorted or may not be 
output. In this case, set the image 
improvement circuit function to off.

• Converted HDMI image output do not 

support “x.v.Colour (x.v.Color)” and Deep 
Colour (Deep Color).

• The resolution of signals that can be 

converted by the receiver is 480i only. Refer 
to the operating instructions of each 
connected component for details on video 
output setting. 

• HDMI video signals cannot be converted to 

component video signals and video signals.

• The converted video signals are not output 

from the MONITOR VIDEO OUT and 
COMPONENT VIDEO MONITOR OUT 
jack.

• The resolution of the signals output to the 

HDMI TV OUT jack are converted up to 
1080p.

When recording, connect the recording 
component to the VIDEO OUT jacks of the 
receiver. Connect cords for input and output 
signals to the same type of jack, as VIDEO 
OUT jacks do not have an up-conversion 
function.

Signals output from the HDMI TV OUT or 
MONITOR OUT jacks may not be recorded 
properly.

HDMI IN

COMPONENT VIDEO IN

VIDEO IN

HDMI TV OUT

COMPONENT VIDEO MONITOR OUT

MONITOR VIDEO OUT