Dirt Devil mse3800 사용자 가이드
BACK
FRONT
FRONT
1. Carry Handle
2. On/Off Switch
3. Dirty Water Tank
4. Clean Water Tank
5. Clean Water/Solution Tube
2. On/Off Switch
3. Dirty Water Tank
4. Clean Water Tank
5. Clean Water/Solution Tube
13. 3 inch Stain Cleaning Brush
14. 6 inch Stair Cleaning Tool
15. Battery Powered Oscillating Hand Tool
14. 6 inch Stair Cleaning Tool
15. Battery Powered Oscillating Hand Tool
* Attachments may vary between models
BACK
6. Lid Release Latch
7. Spray Nozzle
8. Solution Dispense Button
9. Power Cord
7. Spray Nozzle
8. Solution Dispense Button
9. Power Cord
10. Attachment Hose
11. Hose Wrap
12. Quick Release Cord Hooks
11. Hose Wrap
12. Quick Release Cord Hooks
5
FEATURES
3
4
1
5
2
6
8
7
9
10
11
12
ACCESSORIES*
13
14
15
6
HOW TO OPERATE
WARNING: USE ONLY DIRT DEVIL
®
CARPET AND RUG SHAMPOO. USING OTHER CLEANING SOLUTIONS MAY CAUSE
EXCESSIVE FOAMING. EXCESSIVE FOAM WILL CAUSE THE FLOAT TO SHUT OFF THE VACUUM
PREMATURELY. USING OTHER SOAPS WILL VOID YOUR WARRANTY.
PREMATURELY. USING OTHER SOAPS WILL VOID YOUR WARRANTY.
FILLING CLEAN WATER TANK
Press down on the Lid
Release Latch and tilt lid
towards front of cleaner
to access the tanks.
Release Latch and tilt lid
towards front of cleaner
to access the tanks.
Remove Clean Water
Tank by pulling up and
out of cleaner.
Tank by pulling up and
out of cleaner.
Unscrew cap and fill Clean Water Tank with solution
up to the Soap Fill Line (Diagram 3). Fill the rest of
the Clean Water Tank with hot tap water up to the
Water Fill Line (Diagram 3a). IMPORTANT: DO NOT
USE BOILING WATER.
up to the Soap Fill Line (Diagram 3). Fill the rest of
the Clean Water Tank with hot tap water up to the
Water Fill Line (Diagram 3a). IMPORTANT: DO NOT
USE BOILING WATER.
1.
3a.
2.
3.
LID RELEASE
LATCH
Replace Clean Water Tank cap and tighten firmly.
Return Clean Water Tank to cleaner (Diagram 4).
Close lid making sure that the Lid Release Latch
clicks into place (Diagram 4a).
Return Clean Water Tank to cleaner (Diagram 4).
Close lid making sure that the Lid Release Latch
clicks into place (Diagram 4a).
4a.
4.
Connect desired attachment by pressing
tool onto the end of the attachment hose
until the locking button snaps into the
hole. WARNING: Keep spray pointed
away from face. Failure to do so may
result in personal injury.
tool onto the end of the attachment hose
until the locking button snaps into the
hole. WARNING: Keep spray pointed
away from face. Failure to do so may
result in personal injury.
To remove, press down on
the locking button and
pull the tool away from
the hose.
the locking button and
pull the tool away from
the hose.
1.
2.
LOCKING BUTTON
CONNECTING ATTACHMENTS
NOTE: Always turn off appliance before connecting or disconnecting attachments.
ATTACHMENTS