Draytek g2080 부록 매뉴얼
1
Packing List:
Before you start installing VigorSwitch G2080, please verify that the package
contains the following items:
contains the following items:
VigorSwitch G2080
Power Cord
CD
Console Cable
Rubber feet
Rack mount kit
Power Cord
CD
Console Cable
Rubber feet
Rack mount kit
Please notify your sales representative immediately if any of the items is missing or
damaged.
damaged.
Power Requirements:
AC Line
Voltage
: 100
∼240 VAC
Frequency
: 50
∼60 Hz
Consumption
: 13W
Quick Installation:
1.
Install the switch in the rack with mounting accessory.
2.
Connect the switch to an AC power source.
3.
The port 1–8 connector is RJ-45 jack on the switch. Use Category 5 UTP
cable to connect between the switch and end station.
cable to connect between the switch and end station.
4.
The port 7, 8 includes two types of media --- TP and SFP fiber modules; they
support TP or fiber with auto-detected function.
support TP or fiber with auto-detected function.
5.
Use RS-232 interface to pre-configure the switch for network management.
6.
For example: IP address, VLAN, Port Trunking, STP, etc.
The default settings for switch’s serial port are listed as follows:
Baud
rate
57600
Stop
bits
1
Data
bits
8
Parity
N
Flow
control
none
The default values of the switch are listed as follows:
IP Address/Subnet Mask/Default Gateway: Assigned by DHCP Server
Username
Username
:
admin
Password :
admin
User also can use telnet or web to pre-configure the switch with the default IP
address and username/password in the first configuration.
address and username/password in the first configuration.