Siemens E45 사용자 가이드

7G_8G_HS_an_ ISDN-Basen / en / A31008-M1751-X101-2-7619 / appendix.fm / 15.10.2008

Wipe the handset with a damp cloth (do not use solvent) or an antistatic cloth. 

Never use a dry cloth. This can cause static. 

If the handset has come into contact with liquid:

◆

ately. 

◆

Allow the liquid to drain from the handset.

◆

Pat all parts dry, then place the handset with the battery compartment open and the 

keypad facing down in a dry, warm place for at least 72 hours (not in a microwave, 

oven etc.).

◆

Do not switch on the handset again until it is completely dry. 

When it has fully dried out, you will normally be able to use itagain.

If you have any queries about the use of your telephone, you can contact us at any time 

at www.gigaset.com/customercare. The table below contains a list of common 

problems and possible solutions.

The display is blank. 
1.

The handset is not switched on.

◆

Press and hold the End call key 

a.

2.

The batteries are flat.

◆

Charge the battery or replace it.

The handset does not respond to a key press. 
The keypad lock is activated.

◆

Press and hold the hash key 

# .

 "Base station x" is flashing in the display.
1.

The handset is outside the range of the base station.

◆

Reduce the distance between handset/base station.

2.

The handset has been deregistered.

◆

Register the handset (page 20).

3.

The base station is not switched on.

◆

Check the base station mains adapter.

Base Search is flashing in the display. 
The handset is set for Best Base and no base station is switched on or within range.

◆

Reduce the distance between handset/base station.

◆

Check the base station mains adapter.