Dave Smith Instruments mopho 사용자 가이드
18
Resonance: 0…127 —
Sets the Resonance level of the filter. At high settings
the filter will self-oscillate in 4-pole mode. If the filter does not oscillate, switch
to 4-pole mode.
to 4-pole mode.
Keyboard Amount: 0…127 —
Sets the amount of keyboard (MIDI note) to the
filter cutoff. A setting of 64 will step the filter one semitone for each note, 32
would be half-semitones, and so on.
would be half-semitones, and so on.
Audio Mod: 0...127 —
Controls the amount of audio from Oscillator 1 used to
modulate the filter cutoff frequency. For filter-only audio, set O
SCILLATOR
M
IX
to 127, O
SCILLATOR
2
S
HAPE
to Off, and O
SCILLATOR
1
S
HAPE
to the desired
waveshape. This is useful for bell-like FM sounds. A wide range of sounds can
also be made using A
also be made using A
UDIO
M
OD
with the oscillators routed normally through the
filter.
Config: 2 Pole, 4 Pole —
Selects either 2- or 4-pole operation for the filter.
Envelope Amount: -127…+127 —
Sets the amount of filter envelope routed to
the cutoff frequency. This can be positive or negative, allowing inverted
envelope control of the filter.
envelope control of the filter.
Envelope Velocity: 0…127 —
Amount of key velocity controlling the level of
the filter envelope.
Delay: 0...127 —
Sets a delay between the time the filter envelope is triggered
and when the Attack portion actually begins.
Attack: 0…127 —
Sets the Attack time of the filter ADSR envelope generator.
Decay: 0…127 —
Sets the Decay time.
Sustain: 0…127 —
Sets the Sustain level.
Release: 0…127 —
Sets the Release time.
VCA Parameters
VCA Level: 0…127 —
Sets a base level for the VCA (Voltage Controlled
Amplifier). This allows the VCA to be essentially bypassed, which is necessary
for Programs that drone.
for Programs that drone.
Note: If VCA L
EVEL
is on full, Envelope Amount has no effect. You
normally want VCA L
EVEL
set to zero. For droning sounds, or using the
Mopho to process external audio, you will probably turn the VCA Level
up.
up.