Enterasys ssr-atm29-02 사용자 가이드
Chapter 6: Configuring SSR Bridging
66
CoreWatch Users Guide
Note: Clicking a module in the Address Mode list rather than double-clicking it
selects all of the module’s ports that are currently using address-based
bridging. Use this method if you are configuring all the ports on a module to
use flow-based bridging.
bridging. Use this method if you are configuring all the ports on a module to
use flow-based bridging.
5.
Click the Add button.
Configuration Expert moves the selected port from the Address Mode list to the
corresponding module in the Flow Mode list.
corresponding module in the Flow Mode list.
6.
Click OK.
Configuration Expert adds the port to those found in the Flow Mode Bridging object,
which is located in the Bridging Mode object.
which is located in the Bridging Mode object.
Configuring a Port for Address-Based Bridging
Ports are configured to use address-based bridging by default. If you previously
configured a port for flow-based bridging and later decide you want that port to use
address-based bridging, you can change its bridging mode. To do so, take the following
steps:
configured a port for flow-based bridging and later decide you want that port to use
address-based bridging, you can change its bridging mode. To do so, take the following
steps:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file’s
Bridging Configuration object.
Bridging Configuration object.
3.
Double-click the Bridging Mode object.
A Bridging Mode dialog box similar to the following appears: