Enterasys 1805 사용자 가이드

64 ELS100-S24TX2M User Interface

ELS100-S24TX2M

Configuring Static Unicast Addresses

Use the Static Unicast Address Table Configuration screen to manually

configure host MAC addresses in the unicast table. You can use this

screen to associate a MAC address with a specific VLAN ID and switch

port as shown below.

Figure 2-43. Static Unicast Addreeess Table Configuration

SmartSTACK Local Management -- ELS100-S24TX2M

Static Unicast Address Table Configuration

VID MAC Address Unit Port Status

------------------------------------------------------------------------------------

1 00-00-00-E8-43-12 1 1 Permanent

Sorted by : VID + MAC

VID : 1 MAC: 00-00-00-00-00-00

VID : 1

Unit : 1 Port : 1

MAC : 00-00-00-00-00-00 Status : Permanent

[Show] [More] [Set]

<OK>

Use <TAB> or arrow keys to move. < Enter> to select

Parameter

Description

VID

The VLAN group this port is assigned to.

MAC Address

The MAC address of a host device attached to this switch.

Unit

The switch unit the host device is attached to.

Port

The port the host device is attached to.

Status

The status for an entry can be set to:
Permanent:

This entry is currently in use and will remain
so after the next reset of the switch.

DeleteOnReset:

This entry is currently in use and will remain
so until the next reset.

Invalid:

Removes the corresponding entry.

DeleteOnTimeOut: This entry is currently in use and will remain

so until it is aged out. (Refer to Address Table
Aging Time on page 62.)

Other:

This entry is currently in use but the
conditions under which it will remain so differ
from the preceding values.

[Show]

Displays the static address table sorted on VID as the primary key
and MAC address as secondary key.

[More]

Scrolls through entries in the static address table.

[Set]

Adds the specified entry to the static address table, such as
shown in the following example:
VID : 1

MAC : 00-00-00-e8-34-22

Unit : 1

Port : 1

Status : Permanent