Sceptre s6500 사용자 가이드
Notebook User’s Guide
72
Figure 5-3: The Main Battery Module
Notice on the rear of the battery casing there are 5 LEDs and a status button.
Please refer to Figure 5-3. These LEDs indicate how much battery life is
remaining. Press the status button to check the battery’s charge. If all five
LEDs light, the battery is charged to full capacity. Each LED represents
approximately 20% battery charge. There is 80% battery life remaining if four
LEDs are lit. If no LEDs are lit, the battery is fully discharged.
Please refer to Figure 5-3. These LEDs indicate how much battery life is
remaining. Press the status button to check the battery’s charge. If all five
LEDs light, the battery is charged to full capacity. Each LED represents
approximately 20% battery charge. There is 80% battery life remaining if four
LEDs are lit. If no LEDs are lit, the battery is fully discharged.
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recom-
mended by the manufacturer.
mended by the manufacturer.
Dispose of used batteries according to the manufact-
urer’s instructions.
urer’s instructions.
Removing the Battery Pack
To remove the battery pack from its housing, refer to Figure 5-4 and the
following instructions:
following instructions:
1. Turn off the Notebook’s power. Never remove a battery module while the
Notebook is on.
2. Close the Notebook’s cover, ensuring that it snaps into place. Turn the
Notebook so the bottom is facing you.
3. Slide the latch lock in the direction of the arrow (1), as shown in Figure 5-4.