MemoRight 2.5" 128GB SATA SLC GT SSD MR25.2-128S 사용자 설명서

MemoRight NAND Flash-based Solid State Drive 

MemoRight Confidential 

Page 23 

3/6/2009 

This command is similar to Standby immediate. 

This command is similar to Idle immediate.

This command enables the NSSD to transfer the buffer data in cache.   

This command enables the Host to check the NSSD power mode.

This command enables the Host set NSSD into sleep mode.

When this command is issued, the device will flush all data in cache into NSSD disk to protect the data.

This command enables the NSSD to receive the buffer data from host into cache.   

This command is used by the host to request the device to flush the write cache. If there is data in the 
write cache, that data shall be written to the media. The BSY bit shall remain set to one until all data 
has been successfully written or an error occurs.

The Identify Device command (command code EC

H

) transfers information about the drive to the host 

following power up. The data is organized as a single 512-byte block of data, whose contents are 
shown in Table 7 on page 20. All reserved bits or words should be set to zero. Parameters listed with 
an “x” are drive-specific or vary with the state of the drive. See Section 2.0 on page 3 for default 
parameter settings. 

The following commands contain drive-specific features that may not be included in the Draft ATA-7 
Standard.  

Table 16: Drive-specific features 

0 

Configuration information: 
Bit 15: 0=ATA; 1=ATAPI 
Bit 7: removable media 
Bit 6: removable Controller 
Bit 0: reserved 

0040h 

1 

Number of logical cylinders 

3FFFh 

2 

Specific configuration 

C837h 

3 

Number of logical heads 

0010h

 

4 

Retired 

0000h 

5 

Retired 

0000h 

6 

Number of logical sectors per logical track 

003Fh

 

7-9 

Retired 

0000h 

10-19 

Serial number: 20 ASCII characters 

ASCII 

20 

Retired 

0000h