Sony VPL-VW100 사용자 설명서
GB
60
Troubleshooting
On-screen display
Remote control
The LAMP/COVER or TEMP/FAN indicator lights up or flashes if there is
any trouble with your projector.
any trouble with your projector.
The picture is not clear.
c Adjust the focus. (1 pages 25 and 31)
c Condensation has accumulated on the lens. Leave the projector
c Condensation has accumulated on the lens. Leave the projector
for about two hours with the power on.
The fan is noisy.
c Check the setting of “High Altitude Mode” in the Installation
menu. (
The picture flickers.
c Adjust “Dot Phase” for “Adjust Signal” in the Signal
menu
properly. (
Symptom
Cause and Remedy
On-screen display does not
appear.
appear.
c Set “Status” in the Setup
menu to “On.” (
Symptom
Cause and Remedy
The remote control does
not work.
not work.
c Batteries could be weak. Replace them with new batteries. (1
c Insert the batteries with the correct polarities. (1 page 12)
c If there is a fluorescent lamp near the remote control detector,
c If there is a fluorescent lamp near the remote control detector,
the projector may work improperly or inadvertently. Change the
setting of “IR Receiver” in the Installation
setting of “IR Receiver” in the Installation
menu. (
Warning Indicators
TEMP/
FAN
LAMP/
COVER
POWER
SAVING
SAVING
ON/
STANDBY
LAMP/COVER indicator
TEMP/FAN indicator