Sony CDX-1150 설치 설명서
Installation
Installation/Connections
Sony Corporation
1999
Printed in Japan
CDX-1150
Parts for Installation and Connections
The numbers in the list are keyed to those in the instructions.
FM/AM
Compact Disc
Player
Compact Disc
Player
5
1
×
2
2
6
7
3
8
4
Precautions
•Do not tamper with the four holes on the upper surface of the unit. They are for tuner adjustments to be
done only by service technicians.
•Choose the installation location carefully so that the unit will not hamper the driver during driving.
•Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or
•Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or
hot air from the heater, or where it would be subject to dust, dirt or excessive vibration.
•Use only the supplied mounting hardware for a safe and secure installation.
Mounting example
Installation in the dashboard
2
With the TOP marking up
Bend these claws, if necessary.
1
4
3
Dashboard
Fire wall
5
To support the unit
Mounting the unit in a Japanese car
You may not be able to install this unit in some makes of Japanese cars. In such a case, consult your Sony dealer.
TOYOTA
NISSAN
to dashboard/center console
Bracket
to dashboard/center console
7
max. size
5
5
×
6 mm
7
max. size
5
5
×
6 mm
Note
To prevent malfunction, install only with the supplied screws 7.
To prevent malfunction, install only with the supplied screws 7.
×
4
1
3
max. size M4
×
6 mm
2
4
Bracket
7
max. size
5
5
×
6 mm
7
max. size
5
5
×
6 mm
7
max. size 5
×
6 mm
6
6
7
max. size 5
×
6 mm
7
6
1
2
Caution
Cautionary notice for handling the bracket 1.
Handle the bracket carefully to avoid injuring your fingers.
Handle the bracket carefully to avoid injuring your fingers.
TOP
TOP
182 mm
53 mm
TOP
Bracket
Existing parts supplied to your car
Bracket
Existing parts supplied to your car
*I-3-866-374-12*
(1)
Ribs
9
Mounting angle adjustment
Adjust the mounting angle to less than 60°.
1
10 mm (
13
/
32
in./po.)
4 mm (
3
/
16
in./po.)
90º
2
9
Insert the supplied tool 9 between the unit and the frame, and rotate 90° to
release the hidden mounting spring. Repeat on the opposite side and remove
the frame.
release the hidden mounting spring. Repeat on the opposite side and remove
the frame.
Insert a flathead screwdriver between the bracket and mounting spring. Gently
pry the spring toward the unit while pulling the unit out a little. Repeat on the
opposite side and remove the unit.
pry the spring toward the unit while pulling the unit out a little. Repeat on the
opposite side and remove the unit.
Removing the unit
TOP
With the ribs on bottom
1
Note
To prevent malfunction, install
only with the supplied screws 7.
To prevent malfunction, install
only with the supplied screws 7.