EchoStar dvr-5000 hdd 부록 매뉴얼
Section 3
Page 3 - 6
EchoNAV 2.2
© 2
0
0
02 E
choS
tar
Inte
tar
Inte
rnati
onal
C
C
o
rp
orat
io
n
A
ll ri
gh
ts
re
se
se
rv
ed
27. On the RCU:
a. press thekey to set the EL (East limit);
b. at the Motor error, press thekey once;
c. press the OK key.
b. at the Motor error, press thekey once;
c. press the OK key.
28. On the RCU:
a. press thekey to set the WL (west limit);
b. at the Motor error, press thekey once;
c. press the OK key.
b. at the Motor error, press thekey once;
c. press the OK key.
29. Go to the Program satellites field.
30. On the RCU, press the OK key to advance.
31. Select the satellite which you want to receive.
32. Read the available help text for information.
30. On the RCU, press the OK key to advance.
31. Select the satellite which you want to receive.
32. Read the available help text for information.
Note that only the white fields are selectable, other
fields show reference information.
fields show reference information.
33. If you want to add your own defined satellite, go to
the SAT field and select S00 (Goes to the menu
where you can define your own satellite, for
detailed information, refer to section 6. If not
proceed with step 34.
where you can define your own satellite, for
detailed information, refer to section 6. If not
proceed with step 34.
34. When in the Position field:
a. press and hold theor key and watch the
signal indicator for an indication;
b. in the signal indicator, make sure a network
name is shown;
c. press thekey to select another transponder for
signal verification;
d. press thekey to select the Position field;
e. use thekey to fine tune for the best signal
e. use thekey to fine tune for the best signal
level and quality;
f. press the OK key, note that the saved position of
the satellite is shown.
35. If you want to add your own defined transponder
for the selected satellite, go to the TP field and
select TP00 (Goes to the menu where you can
define your own transponder, for detailed
information, refer to section 6). If not proceed with
step 36.
select TP00 (Goes to the menu where you can
define your own transponder, for detailed
information, refer to section 6). If not proceed with
step 36.
36. Go to the Search channels field.
37. On the RCU, press the OK key to advance.
37. On the RCU, press the OK key to advance.
38. Wait for the search to complete:
a. the receiver display shows a moving dot;
b. the Search completed popup menu appears.
b. the Search completed popup menu appears.
39. On the RCU, press the OK key to end the initial
setup procedure.