EchoStar dvr-5000 hdd 부록 매뉴얼
Section 4
EchoStar International Corporation
Page 4 - 7
© 2
002 E
choS
tar
Inte
rnati
onal
C
o
rp
orat
io
n
A
ll ri
gh
ts
re
se
rv
ed
4
2.2.2. FIXED DISH SETUP - SUB-MENU
This sub-menu allows you to customize the system setup to add an additional fixed dish into
your motorized or DiSEqC1.2 configuration. Note that the menu page is dynamic which
means that it changes with the selections you make. You can customize:
your motorized or DiSEqC1.2 configuration. Note that the menu page is dynamic which
means that it changes with the selections you make. You can customize:
2.2.3. PROGRAM SATELLITES - SUB-MENU
This sub-menu allows you to customize the system setup to add an additional satellite into
your receiver. Note that the menu page is dynamic which means that it changes with the
selections you make. You can customize and view:
your receiver. Note that the menu page is dynamic which means that it changes with the
selections you make. You can customize and view:
■
LNBs
To set the amount of LNBs you have installed.
To set the amount of LNBs you have installed.
■
Polarity (DVR-7000 series only)
To set the device that controls the signal polarity.
To set the device that controls the signal polarity.
■
Switch
Shows the switch type which you use to control the
dish installation.
Shows the switch type which you use to control the
dish installation.
■
LNB1
Shows the LNB type which you use on the
motorized dish.
Shows the LNB type which you use on the
motorized dish.
■
LNB2, LNB3, LNB4
To set the LNB type(s) you use on the fixed dish(es).
To set the LNB type(s) you use on the fixed dish(es).
■
SAT
To select the satellite you want to scan for the LNB.
Satellite S00 brings you to the add data menu.
To select the satellite you want to scan for the LNB.
Satellite S00 brings you to the add data menu.
■
Port
To select the switch port for the LNB.
To select the switch port for the LNB.
■
Check signal
To confirm the selections you made and advance to
the Check signal page.
To confirm the selections you made and advance to
the Check signal page.
■
SAT
To select the satellite you want to scan for the LNB.
Satellite S00 brings you to the add data menu.
To select the satellite you want to scan for the LNB.
Satellite S00 brings you to the add data menu.
■
Search mode (for digital receivers only)
To set a specific search mode (All, FTA, IF, TP,
network or update).
To set a specific search mode (All, FTA, IF, TP,
network or update).
■
Search mode (for analog/digital receivers only)
To set a specific search mode (All, FTA, network, TP,
Digital, Analog, Digital IF, Analog IF or update).
To set a specific search mode (All, FTA, network, TP,
Digital, Analog, Digital IF, Analog IF or update).
■
Longitude
To view the satellite location on the Clarke Belt.
To view the satellite location on the Clarke Belt.
■
User LNB
Shows the LNB type which you use on the
motorized dish.
Shows the LNB type which you use on the
motorized dish.