EchoStar dvr-5000 hdd 부록 매뉴얼
Section 3
Page 3 - 2
EchoNAV 2.2
© 2
0
0
02 E
choS
tar
Inte
tar
Inte
rnati
onal
C
C
o
rp
orat
io
n
A
ll ri
gh
ts
re
se
se
rv
ed
F
OR
MOVEABLE
DISH
INSTALLATIONS
(D
I
SE
Q
C 1.2)
27. Wait for the Checking configuration to complete.
28. Read the available help text for information.
29. Make the required selections.
30. If the red dot in the TP field stays:
28. Read the available help text for information.
29. Make the required selections.
30. If the red dot in the TP field stays:
a. select another transponder;
b. go to the Check signal field;
c. on the RCU, press the OK key.
b. go to the Check signal field;
c. on the RCU, press the OK key.
31. If you want to add your own defined transponder,
go to the TP field and select TP00 (Goes to the
menu where you can define your own transponder,
for detailed information, refer to section 6). If not
proceed with step 32.
menu where you can define your own transponder,
for detailed information, refer to section 6). If not
proceed with step 32.
32. Go to the Search channels field.
33. On the RCU, press the OK key to advance.
33. On the RCU, press the OK key to advance.
34. Wait for the search to complete:
a. the receiver display shows a moving dot;
b. the Search completed popup menu appears.
b. the Search completed popup menu appears.
35. On the RCU, press the OK key to end the initial
setup procedure.
21. Make the required selections.
22. Set the required installation mode, recommended
22. Set the required installation mode, recommended
setting is Easy (guided setup procedure).
23. Read the available help text for information.
Note that only the white fields are selectable, other
fields show reference information.
fields show reference information.
24. Go to the Program Satellites field.
25. On the RCU, press the OK key to advance.
25. On the RCU, press the OK key to advance.
26. Select the satellite which you want to receive.
27. Read the available help text for information.
27. Read the available help text for information.
Note that only the white fields are selectable, other
fields show reference information.
fields show reference information.
28. If you want to add your own defined satellite, go to
the SAT field and select S00 (Goes to the menu
where you can define your own satellite, for detailed
information, refer to section 6. If not proceed with
step 34.
where you can define your own satellite, for detailed
information, refer to section 6. If not proceed with
step 34.