Zhone 5100 참조 매뉴얼

CHAPTER 3
Interfaces

Vpacket 5100/6100 Series Reference Manual

In this example, the current T1 WAN interface statistics are shown.

Viewing the WAN state

You can view the state of the WAN interface, which can be up, down, or loopback, by issuing the

show wan state command.
Syntax: show wan state
Example:

------------------- PPP 2 Statistics ----------------------

Bad Addresses : 0

Bad Controls : 0

Packets Too Long : 0

PPP link failures : 0

------------------- MLPPP Statistics ----------------------

Packets Too Long : 0

Transmitted Fragments : 0

Received Fragments : 5942766

Dropped Packets : 0

Transmitted Packets : 2986490

Received Packets : 2983766

VPacket#

VPacket# show wan state

----------------- T1 Interface 1 Status -------------------

Link state : up

Frame Sync : Yes

Loop Back : None

Yellow Alarm (Near RAI) : No

Blue Alarm (Near AIS) : No

Yellow Alarm (Far RAI) : No

Blue Alarm (Far AIS) : No

----------------- T1 Interface 2 Status -------------------