Zhone 5100 참조 매뉴얼

CHAPTER 3
Interfaces

You can configure a WAN interface to use either a frame relay or PPP data protocol by issuing the 

set wan data protocol command. MLPPP is supported for the dual T1 WAN interface model for 

incoming traffic; however, MLPPP fragmentation is not available at this time for traffic forwarded 

from the 6100 VDR.

Note. The 5100/6100 VDR must be reset for changes to take effect.

Syntax: set wan data protocol < mlppp | ppp |funi | atm>
Argument:

mlppp | ppp | funi | atm

for a single T1 model, use ppp; for a dual T1 model, use mlppp; atm 

choice is only viewable from a unit with an SDSL WAN interface

Example:

In this example, MLPPP is chosen for the data protocol. MLPPP is supported on the dual T1 

model only. 

You can set the encapsulation type for the T1 WAN interface (voice and data) by issuing the set 

wan encap command. HDIA encapsulation (1483Bridged, 1490Bridged, or 1490Routed) is 

supported for interoperability with Copper Mountain T1 aggregators.
Syntax: set wan encap <1483Bridged | 1483Routed | 1490Bridged | 1490Routed>
Argument:

1483Bridged | 1483Routed | 1490Bridged |1490Routed

Copper Mountain T1 aggregators (HDIA) support 1483Bridged, 1490Bridged, 

or 1490Routed; the Lucent Stinger supports 1483Bridged or 1483Routed; 

Copper Mountain DSLAM supports 1483Bridged

Example:

In this example, the WAN encapsulation is set to 1483Bridged to interoperate with a Copper 

Mountain T1 aggregator.

VPacket# set wan data protocol mlppp

VPacket#

VPacket# set wan encap 1483Bridged

VPacket#