Zhone 6300 사용자 설명서

C. Traps and MIBs

applTracerouteTestId
(traceroute 1) 

Unique TraceRoute test ID.

Contains applNewTestID after Get.

applTracerouteIpAddress
(traceroute 2)

Destination IP address for 
TraceRoute test.

Set destination IP address.

applTracerouteSourceIpAddress 
(traceroute 3)

Identifies the source IP address.

Set source IP address.

applTraceroutePacketSize
(traceroute 4)

Specifies TraceRoute packet size. 
Range + 28 bytes of header 
information.

„

28 — 15028 – Range.

„

64 – Default.

applTracerouteTimeOut
(traceroute 5)

Timeout value in seconds 
between echo request attempts.

„

10 – Default.

applTracerouteMaxHops
(traceroute 6)

Maximum number of hops to be 
tested.

„

8 – Default.

applTracerouteDomain
(traceroute 7)

Specifies the destination IP 
address’s service domain.

„

mgmt(2) – Management Domain.

„

service(3) – Service Domain. Default.

applTracerouteIfIndex
(traceroute 8)

Specifies the route for the 
TraceRoute test.

If the target interface is not specified, the 
default will display the calculated ifIndex.

applTracerouteTestOwner
(traceroute 9)

Identifies who started the test.

1 – 40 characters.

applTracerouteTestId 
(applTracerouteResultsEntry 1)

Contains the results of a 
TraceRoute test. 

Supports only one test per device.

applTracerouteHopCount 
(applTracerouteResultsEntry 2)

Number of hops to reach the 
gateway.

—

applTracerouteResultsIpAddr
(applTracerouteResultsEntry 3)

IP address of the gateway.

—

applTracerouteResultsHopCount
(applTracerouteResultsEntry 4)

Number of hops to reach the 
gateway.

—

applTracerouteResultsPacketSize
(applTracerouteResultsEntry 5)

Specifies the data size of the 
packets (in bytes) sent during the 
TraceRoute test.

—

applTracerouteResultsProbe1
(appTracerouteResultsEntry 6)

Displays roundtrip time in 100 ms 
intervals of the first probe sent to 
the gateway.

„

0 – Probe has timed out.

applTracerouteResultsProbe2
(applTracerouteResultsEntry 7)

Displays roundtrip time in 100 ms 
intervals of the second probe sent 
to the gateway.

„

0 – Probe has timed out.

applTracerouteResultsProbe3
(applTracerouteResultsEntry 8)

Displays roundtrip time in 100 ms 
intervals of the third probe sent to 
the gateway.

„

0 – Probe has timed out.

diagTestTrapEnable
(configure 1)

Use to enable or disable 
diagApplTestStart and 
diagApplTestStop traps.

Bit Sum.

„

1 – Test Start.

„

2 – Test Over.