Zenith a25a76r 작동 가이드

다운로드
페이지 37
Locate the Antenna/Cable jack on
the back of your Entertainment
Machine.
Connect the cable that runs from
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
and put in two AAA batteries.
Plug in your TV. Do not plug it
into a switched outlet. Your
Entertainment Machine is
designed to operate on household
current, 120-volt 60 Hertz AC. Do
not attempt to operate it on DC
Current.
Go to page 9 to Auto Program
your Entertainment Machine.
206-3450-O
I N S TA L L AT I O N           S TA N DA R D
P A G E   4
Connect 
off-air
antenna your 
Entertainment
Machine 
Hook Up Your Antenna to the TV
RF coaxial wire
(75 ohm) 
Antenna
TV back
TV back panel
(expanded view)
Antenna
Cable
TV back
Flat wire
(300 ohm)
Antenna
300/75 ohm
Adapter
TV back panel
(expanded view)
Antenna
Cable
Audio In Video
Audio In Video
If you have a 75 ohm RF cable,
then you don’t need any adapters!
Remember, when screwing RF
cables onto jacks, clockwise tight-
ens, and counterclockwise loosens.
A 300 to 75 ohm adapter 
is not included with your Zenith
Entertainment Machine.
back of 
remote
1
2
3
4
300 TO 75 OHM 
ADAPTER 
Mini glossary 
75 OHM RF CABLE
The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire 
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two
screws on one end and a round opening with a wire sticking out on the other end. 
5
Flat wire antenna to TV
Round wire antenna to TV