Eagle map guide 사용자 가이드
26
counting until you stop it. When it reaches the alarm’s time setting, a tone
sounds. Press the EXIT key to shut the alarm off.
sounds. Press the EXIT key to shut the alarm off.
The countdown timer starts from a time that you enter and counts down
to zero. (Note: When the countdown timer reaches zero, it begins count-
ing
to zero. (Note: When the countdown timer reaches zero, it begins count-
ing
up
until you press the EXIT key. This tells you how long it’s been since
the alarm sounded.) Use the “DOWN TIMER SETUP” menu to adjust the
countdown timer and reset it to zero.
countdown timer and reset it to zero.
Reprogram Boxes
The digital boxes on MAP 2 and 3 and both NAV screens
can be reprogrammed, changing the informations
shown by the boxes.
The digital boxes on MAP 2 and 3 and both NAV screens
can be reprogrammed, changing the informations
shown by the boxes.
To customize a screen, first switch to the screen that
you want to customize. Map-2 (shown at right) is used
in this example. Next, press the MENU key, then select
the “Reprogram Boxes” menu. The screen shown be-
low left appears.
you want to customize. Map-2 (shown at right) is used
in this example. Next, press the MENU key, then select
the “Reprogram Boxes” menu. The screen shown be-
low left appears.
This is the MAP-2 edit screen. The “BRG” box near the left corner flashes,
which means it’s ready for change. If you don’t want to change this box,
simply press the left or right arrow key to move to the box that you do want
to change. In this example, we will change the bearing (BRG) box to
which means it’s ready for change. If you don’t want to change this box,
simply press the left or right arrow key to move to the box that you do want
to change. In this example, we will change the bearing (BRG) box to
ground speed (GS). To do this, simply press the up or down arrow key
while the box is flashing. The box changes each time the arrow key is
pressed. When the desired box appears, then you can change another
box or save your changes by pressing the ENT key. If you want to leave
this screen without saving the changes, simply press the EXIT key. In this
while the box is flashing. The box changes each time the arrow key is
pressed. When the desired box appears, then you can change another
box or save your changes by pressing the ENT key. If you want to leave
this screen without saving the changes, simply press the EXIT key. In this