ZyXEL 2WG 사용자 가이드
Chapter 8 WAN and 3G Screens
ZyWALL 2WG User’s Guide
174
Since WAN 2 has a smaller load balancing index (meaning that it is less utilized than WAN 1),
the ZyWALL will send the subsequent new session traffic through WAN 2.
the ZyWALL will send the subsequent new session traffic through WAN 2.
8.2.2.3 Example 2
This example uses the same network scenario as in
, but uses both the
outbound and inbound bandwidth utilization in calculating the load balancing index. If the
measured inbound stream throughput for both WAN 1 and WAN 2 is 1600K, the ZyWALL
calculates the average load balancing indices as shown in the table below.
Since WAN 1 has a smaller load balancing index (meaning that it is less utilized than WAN 2),
the ZyWALL will send the next new session traffic through WAN 1.
measured inbound stream throughput for both WAN 1 and WAN 2 is 1600K, the ZyWALL
calculates the average load balancing indices as shown in the table below.
Since WAN 1 has a smaller load balancing index (meaning that it is less utilized than WAN 2),
the ZyWALL will send the next new session traffic through WAN 1.
To configure Least Load First, select Least Load First in the Load Balancing Algorithm
field.
field.
Figure 110 Load Balancing: Least Load First
The following table describes the related fields in this screen.
Table 32 Least Load First: Example 1
INTERFACE
OUTBOUND
LOAD BALANCING INDEX
(M/A)
AVAILABLE (A)
MEASURED (M)
WAN 1
512 K
412 K
0.8
WAN 2
256 K
198 K
0.77
Table 33 Least Load First: Example 2
INTERFACE
OUTBOUND
INBOUND
AVERAGE LOAD
BALANCING INDEX
(OM / OA + IM / IA) / 2
AVAILABLE
(OA)
MEASURED
(OM)
AVAILABLE
(IA)
MEASURED
(IM)
WAN 1
512 K
412 K
8000 K
1600 K
( 0.8 + 0.2) / 2 = 0.5
WAN 2
256 K
198 K
2000 K
1600 K
( 0.77 + 0.8 ) / 2 = 0.79
Table 34 Load Balancing: Least Load First
LABEL
DESCRIPTION
Active/Active
Mode
Select Active/Active Mode and set the related fields to enable load balancing on
the ZyWALL.
Load Balancing
Algorithm
Set the load balancing method to Least Load First.