ZyXEL 2WG 사용자 가이드

Chapter 23 Remote Management Screens

ZyWALL 2WG User’s Guide

The following table describes the labels in this screen. 

Use DNS (Domain Name System) to map a domain name to its corresponding IP address and 
vice versa. Refer to

 for more information.

Click ADVANCED > REMOTE MGMT > DNS to change your ZyWALL’s DNS settings. 
Use this screen to set from which IP address the ZyWALL will accept DNS queries and on 
which interface it can send them your ZyWALL’s DNS settings. This feature is not available 
when the ZyWALL is set to bridge mode.

Table 145   ADVANCED > REMOTE MGMT > SNMP

SNMP 

Configuration

Get Community

Enter the Get Community, which is the password for the incoming Get and GetNext 

requests from the management station. The default is public and allows all requests.

Set Community

Enter the Set community, which is the password for incoming Set requests from 

the management station. The default is public and allows all requests.

Trap

Community

Type the trap community, which is the password sent with each trap to the SNMP 

manager. The default is public and allows all requests.

Destination

Type the IP address of the station to send your SNMP traps to.

SNMP

Service Port

You may change the server port number for a service if needed, however you must 

use the same port number in order to use that service for remote management.

Service Access

Select the interface(s) through which a computer may access the ZyWALL using 

this service.

Secure Client IP 

Address

A secure client is a “trusted” computer that is allowed to communicate with the 

ZyWALL using this service. 
Select All to allow any computer to access the ZyWALL using this service.
Choose Selected to just allow the computer with the IP address that you specify to 

access the ZyWALL using this service.

Apply

Click Apply to save your customized settings.

Reset

Click Reset to begin configuring this screen afresh.