ZyXEL p-660h-61 사용자 가이드

Prestige 660H Series User’s Guide 

37-4 

IP Policy Routing 

Policy Set Name 

This is the policy set name assigned in Menu 25 – IP Routing Policy Setup. 

Active 

Press [SPACE BAR] and then [ENTER] to select Yes to activate or No to deactivate the 
policy. Inactive policies are displayed with a minus sign “-“ in SMT menu 25. 

Criteria  

IP Protocol 

IP layer 4 protocol, for example, UDP, TCP, ICMP, etc. 

Type of Service 

Prioritize incoming network traffic by choosing from Don’t Care, Normal, Min Delay, Max 
Thruput, Min Cost or Max Reliable. 

Precedence 

Precedence value of the incoming packet. Press [SPACE BAR] and then [ENTER] to 
select a value from 0 to 7 or Don’t Care. 

Packet Length 

Type the length of incoming packets (in bytes). The operators in the Len Comp (next 
field) apply to packets of this length. 

Len Comp 

Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal, Less, 
Greater, Less or Equal or Greater or Equal. 

Source:  

addr start / end 

Source IP address range from start to end. 

port start / end 

Source port number range from start to end; applicable only for TCP/UDP. 

Destination:  

addr start / end 

Destination IP address range from start to end. 

port start / end 

Destination port number range from start to end; applicable only for TCP/UDP. 

Action 

Specifies whether action should be taken on criteria Matched or Not Matched. 

Gateway addr 

Defines the outgoing gateway address. The gateway must be on the same subnet as the 
Prestige if it is on the LAN, otherwise, the gateway must be the IP address of a remote 
node. The default gateway is specified as 0.0.0.0. 

Type of Service 

Set the new TOS value of the outgoing packet. Prioritize incoming network traffic by 
choosing No Change, Normal, Min Delay, Max Thruput, Max Reliable or Min Cost. 

Precedence 

Set the new outgoing packet precedence value. Values are 0 to 7 or No Change. 

Log 

Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the system log 
when a policy is executed. 

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to cancel” 
to save your configuration or press [ESC] to cancel and go back to the previous screen. 

This section shows you where to apply the IP policies after you design them. 

From Menu 3 — Ethernet Setup, type 2 to go to Menu 3.2 — TCP/IP and DHCP Ethernet Setup. 

You can choose up to four IP policy sets (from 12) by typing their numbers separated by commas, for 
example, 2, 4, 7, 9.