ZyXEL p-2302hw-p1 사용자 설명서

P-2302HW/HWL-P1 Series User’s Guide

214

Chapter 17 Bandwidth MGMT

Use this screen to look at the configured bandwidth classes by individual interface. Each 
interface has a permanent root class. The bandwidth budget of the root class is equal to the 
speed you configured on the interface (see 

). There is a default class 

for all the bandwidth in the Root Class that is not allocated to bandwidth classes.

Note: For each interface, you must enable bandwidth management before you can 

configure classes.

To access this screen, click Management > Bandwidth MGMT > Class Setup.

Figure 115   Management > Bandwidth MGMT > Class Setup

Each field is described in the following table.

Table 92   Management > Bandwidth MGMT > Class Setup

Class Setup

Interface

Select the interface for which you wish to set up classes.

Bandwidth management controls outgoing traffic on an interface, not incoming. In 
order to limit the download bandwidth of the LAN users, set the bandwidth 
management class on the LAN. In order to limit the upload bandwidth, set the 
bandwidth management class on the corresponding WAN interface.

Root Class

In this section, you can look at each class and its allocated bandwidth. Select the 
class to which you want to add a sub-class, which you want to edit, or which you 
want to delete.

If you used the Bandwidth Management Wizard, each service you selected 
(except WWW) becomes a LAN sub-class and a WAN sub-class in this screen. 
WWW only becomes a LAN sub-class.

Add Sub-Class

Click this to add a sub-class to the selected class.

Edit

Click this to configure the selected class. You cannot edit the root class. The 
Bandwidth Class Edit screen appears.

Delete

Click this to delete the selected class and all its sub-classes. You cannot delete the 
root class.