ZyXEL 793H 사용자 가이드

 Chapter 26 Remote Node Setup

P-793H User’s Guide

The following explains how to configure remote node 8 for the dial backup connection.

Bridge

If Route is IP, select Yes in this field to enable bridging to this remote node for 

protocols that are not supported by IP-based routing (for example, SNA).
If Route is None, select Yes in this field to enable bridging to this remote node 

for all protocols.
In either case, this setting is not effective unless you enable bridging in the 

ZyXEL Device too. See 

.

You should enable Route IP, Bridge, or both in this screen. If you disable 

Route IP and Bridge, the device does not send traffic between the LAN ports 

and remote node.

Edit IP/Bridge

This field is enabled if Route is IP. If you want to set up the WAN IP address 

and advanced features for the WAN port, press [SPACE BAR] to select Yes 

and press [ENTER]. Menu 11.3 appears.

Edit ATM Options

This field is enabled if Route is IP. Press [SPACE BAR] to select Yes and 

press [ENTER] to edit the virtual channel and ATM QoS settings. Menu 11.6 

appears.

Edit Advance Options This field is displayed if you are editing remote node 1, and it is only enabled 

for PPPoE connections. If you want to set up advanced features for the 

Internet connection, press [SPACE BAR] to select Yes and press [ENTER]. 

Menu 11.8 appears.

Telco Option

This section is only enabled for PPPoA or PPPoE connections.

Allocated 

Budget(min)

Enter the maximum amount of time (in minutes) each call can last. Enter 0 if 

there is no limit. With Period, you can set a limit on the total outgoing call time 

of the ZyXEL Device within a certain period of time. When the total outgoing 

call time exceeds the limit, the current call will be dropped and any future 

outgoing calls will be blocked.

Period(hr)

Enter how often (in hours) the Allocated Budget is reset. For example, if you 

can call for thirty minutes every hour, set the Allocated Budget to 30, and set 

this field to 1.

Schedule Sets

Enter the schedule sets that apply to this connection.

Nailed-Up 

Connection

Select this if you want the ZyXEL Device to automatically connect to your ISP 

when it is turned on and to remain connected all the time. This is not 

recommended if you pay for your Internet connected based on the amount of 

time you are connected.

Session Options

Edit Filter Sets

If you want to specify input and output filter sets for the WAN port, press 

[SPACE BAR] to select Yes and press [ENTER]. Menu 11.5 appears.

Idle Timeout(sec)

Enter the number of seconds the ZyXEL Device should wait while there is no 

Internet traffic before it automatically disconnects from the ISP. Enter a time 

interval between 10 and 9999 seconds.

Table 102   Menu 11.1: Remote Node Profile (nodes 1-7) (continued)