ZyXEL 793H 사용자 가이드

Chapter 3 Wizards

P-793H User’s Guide

Use these screens to configure Internet access settings. To access this wizard, click 
INTERNET SETUP in the wizard main screen.

This screen lets you enter some of the ISP settings for your Internet connection.

Figure 12   Internet Access Wizard Setup: ISP Parameters

The following table describes the fields in this screen.

Table 6   Internet Setup Wizard: ISP Parameters

Mode

Select Routing (default) if your ISP allows multiple computers to share an Internet 

account. Otherwise, select Bridge.

Encapsulation

Select the encapsulation type your ISP uses from the Encapsulation drop-down list 

box. Choices vary depending on what you select in the Mode field. 
If you select Bridge in the Mode field, select either PPPoA or RFC 1483. 
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or 

PPPoE.

Multiplexing

Select the multiplexing method used by your ISP from the Multiplex drop-down list 

box either VC-based or LLC-based. 

Virtual Circuit 

ID

VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit. 

Refer to the appendix for more information.

VPI

Enter the VPI assigned to you. This field may already be configured.

VCI

Enter the VCI assigned to you. This field may already be configured.

Back

Click Back to go back to the previous screen.

Next

Click Next to continue to the next wizard screen. The next wizard screen you see 

depends on what mode and encapsulation you selected above.

Exit

Click Exit to close the wizard screen without saving your changes.