ZyXEL 793H 사용자 가이드

 Chapter 5 WAN Setup

P-793H User’s Guide

This section describes the protocol-independent parameters for a remote network. They are 
required for placing calls to a remote gateway and the network behind it across a WAN 
connection. When you use the WAN > Internet Connection screen to set up Internet access, 
you are configuring the first WAN connection.
Click Network > WAN > More Connections to display the screen as shown next.

Figure 29   WAN > More Connections

The following table describes the labels in this screen.

Use this screen to configure a connection. Click the edit icon in the More Connections screen.

Table 18   WAN > More Connections

#

This is the index number of a connection.

Active

This display whether this connection is activated. Clear the check box to disable 

the connection. Select the check box to enable it.

Name

This is the descriptive name for this connection.

VPI/VCI

This is the VPI and VCI values used for this connection.

Encapsulation

This is the method of encapsulation used for this connection.

Modify

The first (ISP) connection is read-only in this screen. Use the WAN > Internet 

Connection screen to edit it.
Click the edit icon to go to the screen where you can edit the connection.
Click the delete icon to remove an existing connection. You cannot remove the 

first connection.

Apply

Click Apply to save the changes. 

Cancel

Click Cancel to begin configuring this screen afresh.