ZyXEL 793H 사용자 가이드

Chapter 5 WAN Setup

P-793H User’s Guide

CLID

Enter the keyword that precedes the CLID (Calling Line Identification) in the AT 

response string. This lets the ZyXEL Device capture the CLID in the AT response 

string that comes from the WAN device. CLID is required for CLID authentication.

Called ID

Enter the keyword preceding the dialed number.

Speed

Enter the keyword preceding the connection speed.

Call Control

Dial Timeout

Enter a number of seconds for the ZyXEL Device to keep trying to set up an 

outgoing call before timing out (stopping). The ZyXEL Device times out and stops if 

it cannot set up an outgoing call within the timeout value. 

Retry Count

Enter a number of times for the ZyXEL Device to retry a busy or no-answer phone 

number before blacklisting the number.

Retry Interval

Enter a number of seconds for the ZyXEL Device to wait before trying another call 

after a call has failed. This applies before a phone number is blacklisted. 

Drop Timeout

Enter a number of seconds for the ZyXEL Device to wait before dropping the DTR 

signal if it does not receive a positive disconnect confirmation.

Call Back Delay

Enter a number of seconds for the ZyXEL Device to wait between dropping a 

callback request call and dialing the corresponding callback call.

Back

Click Back to return to the previous screen.

Apply

Click Apply to save the changes. 

Cancel

Click Cancel to begin configuring this screen afresh.

Table 23   WAN > WAN Backup Setup > Advanced Setup > Edit (continued)