Sharp MX-M260 사용자 설명서
136
TROUBLESHOOTING AND MAINTENANCE
Removing staple jams
Follow the steps below to remove a staple jam.
1
Open the cover.
2
While pressing the lever over to the
left, slide the finisher to the left until it
stops.
left, slide the finisher to the left until it
stops.
Gently slide the finisher
until it stops.
until it stops.
3
Lower the staple case release lever
and remove the staple case.
and remove the staple case.
Pull the staple case out
to the right.
to the right.
4
Raise the lever at the front end of the
staple case and remove the jammed
staple.
staple case and remove the jammed
staple.
Remove the leading
staple if it is bent. If bent
staples remain, a staple
jam will occur again.
staple if it is bent. If bent
staples remain, a staple
jam will occur again.
5
Lower the lever at the front end of the
staple case.
staple case.
6
Replace the staple case.
Push the staple case in
until it clicks into place.
until it clicks into place.
7
Slide the finisher back to the right.
Gently slide the finisher
back to the right until it
locks into its original
position.
back to the right until it
locks into its original
position.
8
Close the cover.
Gently slide the finisher
back to the right until it
locks into its original
position.
back to the right until it
locks into its original
position.
Take care that a bent staple does not hurt
you.
you.
Caution
07.fm 136 ページ 2009年7月8日 水曜日 午後5時32分