Maytag mcd2358wem 사용자 설명서

NOTE: Not all bulbs will fit your refrigerator. Be sure to replace 
the bulb with one of the same size, shape and wattage. 
Replacement bulbs are available from your dealer.

■

The dispenser lights are LEDs that cannot be changed.

■

All other lights require a 40-watt bulb.

1. Unplug refrigerator or disconnect power.

2. Remove light shield when applicable. 

NOTE: To clean the light shield, wash it with warm water and 
liquid detergent. Rinse and dry the shield well.

3. Remove light bulb and replace with one of the same size, 

shape and wattage.

4. Replace light shield when applicable.

5. Plug in refrigerator or reconnect power.

■

Power cord unplugged? Plug into a grounded 3 prong 
outlet.

■

Is outlet working? Plug in a lamp to see if the outlet is 
working.

■

Household fuse blown or circuit breaker tripped? Replace 
the fuse or reset the circuit breaker. If the problem continues, 
call an electrician.

■

Are controls on? Make sure the refrigerator controls are on. 
See “Using the Controls.”

■

New installation? Allow 24 hours following installation for the 
refrigerator to cool completely.   

NOTE: Adjusting the temperature controls to coldest setting will 
not cool either compartment more quickly.

Your new refrigerator may run longer than your old one due to its 
high-efficiency compressor and fans. To maximize energy 
efficiency, the compressor changes speed to provide just the 
right amount of cooling as it is needed. Your refrigerator may run 
as much as 100% of the time, but it will still use less energy than 
an older refrigerator. You may notice that it runs more often when 
the room is warm, a large amount of food is added to either 
compartment, or the doors are opened often.

Refrigerator noise has been reduced over the years. Due to this 
reduction, you may hear intermittent noises from your new 
refrigerator that you did not notice from your old model. Below 
are listed some normal sounds with an explanation.

■

Buzzing - heard when the water valve opens to fill the ice 
maker

■

Pulsating - fans/compressor adjusting to optimize 
performance

■

Rattling - flow of refrigerant, water line, or from items placed 
on top of the refrigerator

■

Sizzling/Gurgling - water dripping on the heater during 
defrost cycle

■

Popping - contraction/expansion of inside walls, especially 
during initial cool-down

■

Water running - may be heard when ice melts during the 
defrost cycle and water runs into the drain pan

■

Creaking/Cracking - occurs as ice is being ejected from the 
ice maker mold.