Maytag mvwx600x 사용자 가이드

Replace inlet hoses after 5 years of use to reduce the risk of 

hose failure. Periodically inspect and replace inlet hoses if 

bulges, kinks, cuts, wear, or leaks are found.

When replacing your inlet hoses, mark the date of replacement 

on the label with a permanent marker.

 Dispenser trays are not dishwasher safe.

You may find laundry product residue leftover in your 

dispenser trays. To remove residue, follow this recommended 

cleaning procedure:
1.  Pull tray out until you feel resistance.
2.  Lift up slightly, and then continue pulling out.
3.  Wash in warm, soapy water, using a mild detergent.
4.  Rinse with warm water.
5.  Air dry, or dry with a towel, then place back into slot.

Operate your washer only when you are home. If moving, or  

not using your washer for a period of time, follow these steps:
1.  Unplug or disconnect power to washer.
2.  Turn off water supply to washer, to avoid flooding due to 

water pressure surge.

 To avoid damage, install and store washer 

where it will not freeze.  Because some water may stay  

in hoses, freezing can damage washer. If storing or moving 

during freezing weather, winterize your washer.
To winterize washer:
1.  Shut off both water faucets; disconnect and drain water     

inlet hoses.

2.  Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run 

washer on RINSE & SPIN cycle for about 30 seconds  

to mix antifreeze and remaining water.

3.  Unplug washer or disconnect power.

Keep your washer as clean and fresh as your clothes. To keep 

washer interior odor-free, follow this recommended cleaning 

procedure after every 30 washes:

1.  Make sure the washer is empty.
2.  Using recommended AFFRESH

®

 washer cleaner, add one 

tablet to washer drum.

 OR
      If using liquid chlorine bleach, add 1 cup (250 mL) to liquid 

chlorine bleach dispenser.

IMPORTANT: Do not add detergent to CLEAN WASHER 

with AFFRESH™ cycle. Do not use more than recommended 

amount of bleach to avoid damaging product over time.
3.  Close washer lid.
4.  Press POWER.
5.  Select CLEAN WASHER with AFFRESH™ cycle.  
6.  Press START/Pause/Unlock. 
NOTE: For best results, do not interrupt cycle. If cycle must  

be interrupted, press POWER and run a RINSE & SPIN  

cycle to ensure cleaner or bleach have been rinsed from 

washer.
To clean exterior:
1.  Use a soft, damp cloth or sponge to wipe up any spills.
2.  Use all-purpose surface cleaner, if needed. 
IMPORTANT: To avoid damaging the washer’s finish, do not 

use abrasive products.

1.  Shut off both water faucets. Disconnect and drain water     

inlet hoses.

2.  If washer will be moved during freezing weather, follow     

WINTER STORAGE CARE directions before moving.

3.  Disconnect drain from drain system and drain any  

remaining water into a pan or bucket. Disconnect drain  

hose from back of washer.

4.  Unplug power cord.
5.  Place inlet hoses and drain hose inside washer basket.
6.  Drape power cord over edge and into washer basket.
7.  Place packing tray from original shipping materials back 

inside washer. If you do not have packing tray, place heavy 

blankets or towels into basket opening. Close lid and place 

tape over lid and down front of washer. Keep lid taped until 

washer is placed in new location.