MicroBoards pf3-1000 사용자 가이드
• Troubleshooting
20
Out of Ink Message
If you do not change the cartridge when the Low Ink warnings first appear, you will run the risk of
draining the cartridge completely, affecting print quality and potentially damaging the printer. The Out
of Ink message will appear when the ink levels of specified the cartridge can no longer be safely
used.
draining the cartridge completely, affecting print quality and potentially damaging the printer. The Out
of Ink message will appear when the ink levels of specified the cartridge can no longer be safely
used.
It is strongly recommended that you do not wait for the ink to be completely drained. You
should change the cartridges when or shortly after the Low Ink warning appears.
should change the cartridges when or shortly after the Low Ink warning appears.
When the Out of Ink message appears, the current print job will be cancelled. At that point, please
follow the steps below, in the order in which they are listed:
follow the steps below, in the order in which they are listed:
1. Open the front door of the PF-3 Print Factory.
2. When the carriage moves to center, remove the ink cartridge specified in the message.
3. Replace the cartridge and close the front door.
4. Press the Cancel button on the front printer control panel.
5. Wait for the printer to prime the cartridge. The priming cycle will
take approximately 70-80 seconds to complete. Do not perform the
next step until the priming cycle completes.
next step until the priming cycle completes.
6. After the disc ejects, click the OK button on the Out of Ink message.
If you do not wait for the cartridge priming cycle to complete and you have additional print jobs waiting
in the print queue, you may have to clear the print queue before the printer will respond. During the
PF-3 installation, a shortcut to a utility to clear the print queue was added to your PC. Please note
that this utility will clear all print jobs currently in the print queue for any printer.
in the print queue, you may have to clear the print queue before the printer will respond. During the
PF-3 installation, a shortcut to a utility to clear the print queue was added to your PC. Please note
that this utility will clear all print jobs currently in the print queue for any printer.
To run the utility, click the Start button and select either Programs or All Programs, depending on the
Operating System and the Start Button behavior. Click the Microboards entry, then PF-3 Print
Factory. Click the Print Queue Utility shortcut in the Toolbox directory. After the utility opens, click
the Clear Print Queue button to remove all pending print jobs on your PC. The queue will clear in
approximately 10 seconds; when it is complete, you can begin printing again.
Operating System and the Start Button behavior. Click the Microboards entry, then PF-3 Print
Factory. Click the Print Queue Utility shortcut in the Toolbox directory. After the utility opens, click
the Clear Print Queue button to remove all pending print jobs on your PC. The queue will clear in
approximately 10 seconds; when it is complete, you can begin printing again.