Runco rs 440lt 사용자 가이드
Runco RS-440 Installation/Operation Manual
29
PRE
L
IMINAR
Y
Connecting 12-Volt
Trigger Output to External
Theater Equipment
Trigger Output to External
Theater Equipment
If your home theater contains a retractable screen, screen mask or other 12-volt
trigger-activated equipment, connect it to the 12-volt trigger output as shown in Figure
3-14.
trigger-activated equipment, connect it to the 12-volt trigger output as shown in Figure
3-14.
Figure 3-14. Connecting the 12-Volt Trigger Output to Other Equipment
3.7
Turning on the Power
Turning on the Power
1.
Turn on your source components.
2.
Plug the female end of the power cord into the
AC receptacle on the rear of the RS-440 (AC
100V ~ 240V). (The RS-440 ships with various
types of AC power cords. Choose the one that
is appropriate to your locale.)
AC receptacle on the rear of the RS-440 (AC
100V ~ 240V). (The RS-440 ships with various
types of AC power cords. Choose the one that
is appropriate to your locale.)
3.
Connect the other end to your AC power
source. The power indicator lights blue to
indicate that the RS-440 is in “standby” mode.
source. The power indicator lights blue to
indicate that the RS-440 is in “standby” mode.
4.
Press the ON button on the remote control to
turn on the projector. The power indicator
turns off.
turn on the projector. The power indicator
turns off.
5.
After a brief warm-up period (approximately 10 seconds), the RS-440 will start
projecting.
projecting.
Retractable Screen
or other, 12-volt
trigger-activated equipment
Red = +12V (Tip)
Black = Ground (Sleeve)
3.5-mm
mini plug
mini plug