Runco VX-6000D 사용자 가이드
74
Runco VX-6000d Installation/Operation Manual
L
IMINAR
Y
Select Information from the Main Menu, then select Signal Info from the Information menu
to display the resolution, horizontal frequency and vertical frequency of the current input
signal.
to display the resolution, horizontal frequency and vertical frequency of the current input
signal.
Select Options from the Main Menu to perform the following projector configuration tasks.
Subtitle: Select Subtitle from the Options menu to adjust the projected image height in
small increments.
small increments.
Reset to Defaults: To reset the Overscan setting to its default value, select Reset to
Defaults from the Options menu, then select Yes to confirm the reset.
Defaults from the Options menu, then select Yes to confirm the reset.
• When set to ON, the LEDs indicate operating status as described in VX-2000d at a
• When set to OFF, the LEDs illuminate when the VX-6000d is in standby mode, warming
up or indicating an error condition; otherwise, they are off.
Lamp Hours (read-only): Refer to Lamp Hours on page 65.
OSD: When you select an aspect ratio or input with the remote control (or from the DHD
Controller), the VX-6000d displays your selection on-screen. To prevent the display of
these items, select OSD from the Options menu and set it to Off.
Controller), the VX-6000d displays your selection on-screen. To prevent the display of
these items, select OSD from the Options menu and set it to Off.
➤
Frequency
Phase
H-Shift
V-Shift
Reset to Defaults
Special Modes
Signal Info
Auto Setup
Information
➤
Image Shift
Subtitle
Overscan 0%
Reset to Defaults
Adjust White Level
Adjust Black Level
LED On
Lamp Hours
OSD On
Signal Type
3
Color Space
HDMI Black Level
0
Splash Screen Color
Black
Power Save
Baud Rate
9600 bps
Fan Mode
1
Orientation FF
Factory Default
Options
Image Shift and Subtitle can only be adjusted for certain 1080i
signals.
signals.
When you set the Auto Power Off function (refer to Power Save,
below) to Off, the LED function is automatically set to On.
below) to Off, the LED function is automatically set to On.
Note
Note