Fortinet FORTIWIFI-50B 설치 설명서

Go to Firewall > Policy.

Select Create New.

Set the following and select OK.

Go to Firewall > Policy.

Select Create New.

Set the following and select OK.

Firewall policy configuration is the same in NAT/Route mode and Transparent 
mode.

Note that these policies allow all traffic through. No protection profiles have been 
applied. Ensure you create additional firewall policies to accommodate your 
network requirements.

After connecting to the CLI, you can use the following procedures to complete the 
basic configuration of the FortiWiFi unit. Ensure you read the section 

 before beginning.

The FortiWiFi unit comes preset to NAT mode. You need to switch to Transparent 
mode.

config system settings

set opmode transparent
set manageip <address_ip> <netmask>
set gateway <address_gateway>

end

Select the port connected to the network.

All

Destination Interface Select the port connected to the Internet.
Destination Address All
Schedule

always

Any

Accept

Select the port connected to the Internet.

All

Destination Interface Select the port connected to the network.
Destination Address All
Schedule

always

Any

Accept