Knoll gs12 사용자 설명서

 
GS12 Rear Panel 

 
 
 

 
 

 
 

 
 

 
 
 

 
 

 

The Link button is normally set to the in position to give 
all six stereo inputs individual sources. When a channel 

Link button is set to the out position, that channel is 
(Left/Right) linked or cascaded to input #1 (without the 
use of Y cords). Any or all combinations of linked inputs 2 
to inputs 6 are possible. When all inputs are linked to 
input one, the input impedance is about 8500 ohms. 

 
 
Note: When linked unused RCA inputs can be used as 
outputs to other amplifiers. 

 

 
 

 
 

 
 
 

 
Note 1: Ideal speaker impedance is 6-8 ohms.  

less than 4 ohms or amplifier damage not covered by the 
warranty may occur. 

 
 

 

 
 

 
 

 
 

 
 
 

 
 

 

 
The “SENS” pot controls the level threshold setting of the 

automatic power on and off to all channels. Each channel 
turns on and off individually. 
 
Power On 
Initially adjust the “SENS” on to about 1/3 level. Turn on a 
source to one or more channels and see if the channel 

turns on (observe the front panel led). With soft music on, 
the channel should sense the music and turn on. If it does 
not turn on, try turning the “SENS” adjustment counter 
clockwise slowly until the channel turns on. 
 

Power Off 
If the channel does not turn off about 3-30 seconds after 
a source has been muted or shut off, adjust the “SENS” 
slowly clockwise and wait 30 seconds. If it still does not 
turn off, turn it a bit more clockwise and wait another 30 

seconds. Keep doing this until the channel turns off in 3-
30 seconds.