Thetford 1082 사용자 설명서
This refrigerator allows the owner to change the door swing if desired. The hinging of the doors can be changed
to the opposite side anytime you wish.
TOOLS REQUIRED
Phillips Screwdriver - Size #2
Two Slotted Screwdrivers
Two Slotted Screwdrivers
REMOVING THE DOORS
1. Turn ELEC-OFF-GAS switch, located on the control panel, to
OFF. Remove all items of food, juices, etc., from the doors.
Remove the juice rack and storage bins. Close both doors
before removing hinge pins.
Remove the juice rack and storage bins. Close both doors
before removing hinge pins.
2. Remove the top hinge pin using one of the slotted screwdrivers.
Remove the center hinge pin (both pieces) using the two slotted
screwdrivers; one on each end of the pin. Lastly, remove the
bottom hinge pin. Be sure to save the pins for reassembly later.
(See Figure 12)
screwdrivers; one on each end of the pin. Lastly, remove the
bottom hinge pin. Be sure to save the pins for reassembly later.
(See Figure 12)
3. Remove the upper door by opening the door slightly and pulling
the bottom of the door away from the refrigerator. Allow enough
room to slide the door down off of the upper hinge pin shoulder.
(See Figure 6)
room to slide the door down off of the upper hinge pin shoulder.
(See Figure 6)
4. Remove the lower door by opening it slightly and pulling the top
of the door away from the refrigerator. Allow enough room so
the door can be lifted up and off of the bottom hinge pin shoulder
(See Figure 7). Be sure to save the hinge plates along with the
spacer used in the middle hinge bracket, for reassembly later.
(See Figures 12 - A, B, and C)
the door can be lifted up and off of the bottom hinge pin shoulder
(See Figure 7). Be sure to save the hinge plates along with the
spacer used in the middle hinge bracket, for reassembly later.
(See Figures 12 - A, B, and C)
REMOVING AND RELOCATING THE HINGE BRACKETS
5. Remove the middle hinge bracket by using the #2 Phillips screwdriver and taking out the three screws holding
it in place. Next, remove the three screws on the opposite side corresponding to the center hinge location.
Relocate them in the holes just exposed by the removal of the hinge bracket. Attach the hinge bracket to the
refrigerator where the hole plugs previously were. Do not tighten screws completely. (See Figure 8)
Relocate them in the holes just exposed by the removal of the hinge bracket. Attach the hinge bracket to the
refrigerator where the hole plugs previously were. Do not tighten screws completely. (See Figure 8)
6. Remove the top hinge bracket and reposition it in the opposite bottom corner. Use the same technique as
outlined in Step #5.
7. Remove the bottom hinge bracket and reposition it in the opposite top corner. Use the same technique as
outlined in Step #5.
Re
ve
rs
in
ve
rs
in
g
D
o
o
o
r
Sw
in
g
Instructions for Reversing Door Swing
Figure 8
Figure 7
Figure 6
6