Thetford 1210 사용자 가이드
Owner’s Manual 3
4. Push in and hold the dispenser arm [1] until the water flows out in a steady
stream and does not sputter (See Art01791).
NOTE: This may take a minute for the built-in reservoir to fill for the first time and to
eliminate the air from the system. You should discard and not use the first
several glasses of water from the dispenser. New plumbing connections
and/or impurities in the water supply line from the first use or after winteriz-
ing can cause the first glasses of water to be discolored or have an odd
flavor.
several glasses of water from the dispenser. New plumbing connections
and/or impurities in the water supply line from the first use or after winteriz-
ing can cause the first glasses of water to be discolored or have an odd
flavor.
5. Release the paddle to stop the water flow.
6. Remove the glass from below the dispenser nozzle.
Continued operation:
1. Allow the water in the dispenser to cool before using the dispenser.
- The cooling time will vary with the supply water temperature.
- A complete refill of the built-in reservoir will take longer
2. Make sure that the air inside the refrigerator can freely circulate around the
water reservoir which is located at the rear of the fresh food compartment.
NOTE: Do not stack food tightly in front of the water reservoir. If the air inside
the refrigerator can not circulate around the water reservoir, the water
in the dispenser will not cool correctly. Do not set hot food against the
front of the water reservoir.
in the dispenser will not cool correctly. Do not set hot food against the
front of the water reservoir.
3. Hold a glass below the dispenser nozzle.
4. Push in and hold the dispenser arm [1] (See Art01791) to start the water
flow.
5. Release the paddle to stop the water flow.
6. Remove the glass from below the dispenser nozzle.
Water dispenser shut off:
If the water dispenser does not shut off when you release the paddle:
- Push the refrigerator ON/OFF button to turn the refrigerator off.
- See the “Troubleshooting” section of these instructions to find the cause of
the problem.
Task light:
The task light comes on whenever the water dispenser is on.
Drain grid and drip cup:
The drain grid and drip cup are located below the water dispenser arm.
To remove the drain grid [3], push down on the center of the rear edge of the
drain grid to raise up the front edge so you can grasp it (See Art01792).
drain grid to raise up the front edge so you can grasp it (See Art01792).
To remove the drip cup [4], grasp the handle area inside the drip cup and lift
it out of the well (See Art01793).
it out of the well (See Art01793).
Art01791
1
2
3
Art01792
4
Art01793