Becker highspeed 7934 작동 가이드

> US

GENERAL OPERATIONS

>>>

Vertical movements
> Loosen the fastening screws (2) on both

sides far enough to be able to swivel the
carrier plate (7) downward from above
without exerting excessive force.

> Use one hand to hold the foot (5) and

swing the support plate (7) up to the
center or down into the position you
want.

> Tighten the fastening screws (2) suffi-

ciently so that the Traffic Assist High-
speed is held securely in place when the
vehicle is in motion.

Horizontal movements
> Loosen the locking screw (1) until the

support plate (7) can be swung from left
to right without too much effort.

> Use one hand to hold the foot (5)

and swing the support plate (7) to the
left, to the center or to the right into the
position you want.

> Retighten the locking screw (1) again so

that the Traffic Assist Highspeed is se-
cure for travel.

The unit holder (6) is equipped with four
guides, the carrier plate (7) has corre-
sponding retaining lugs.
> Position the unit holder with the guides

onto the carrier plate retaining lugs.

> Slide the unit holder downward to the

stop.

The Traffic Assist Highspeed has recepta-
cles for the unit holder on the top and bot-
tom of the housing.
> Insert the Traffic Assist Highspeed into

the unit holder with the receptacles on
the bottom of the housing.

> Press the Traffic Assist Highspeed into

the unit holder without employing ex-
cessive force until the clip (8) engages in
the receptacle.

The Traffic Assist Highspeed is fitted with
a touchscreen.

Note:
To remove the Traffic Assist Highspeed,
press the clip (8) on the unit holder with
one finger and remove the unit from the
unit holder using your free hand.

Note:
To ensure that the display's surface is not
damaged, you may only touch it with
your fingers or a blunt, non-smearing ob-
ject.