Valcom v1010c 설치 설명서
2
947295
FIGURE 1: TYPICAL CONNECTIONS
NOTE: Do not connect this speaker directly
to a 25/70/100 Volt amplifier as damage to
both the amplifier and speaker may occur.
A V-1095 may be used to allow the use of
Valcom self-amplified speakers on 70V
speaker lines.
to a 25/70/100 Volt amplifier as damage to
both the amplifier and speaker may occur.
A V-1095 may be used to allow the use of
Valcom self-amplified speakers on 70V
speaker lines.
Page
Out
Out
Valcom Page
Control
Control
(Tip/A)
(Ring/B)
(-24VDC)
(Gnd)
(Ring/B)
(-24VDC)
(Gnd)
Valcom -24VDC
Power Supply
Power Supply
One-Way
Amplified
Speaker
Amplified
Speaker
FIGURE 2: V-1010C INSTALLATION INSTRUCTIONS
V-9915M-5 Backbox
V-9904M-5 Bridge
Bend tabs down to
locate bridge in
ceiling tile
cutout.
locate bridge in
ceiling tile
cutout.
Attach backbox to
bridge using 4 screws
provided
bridge using 4 screws
provided
Cut 5.25" round
hole in ceiling tile
hole in ceiling tile
4" Ceiling Grille
and Speaker
and Speaker
The V-9904M-5 is recommended
for use where extra speaker
support is needed. A V-9915M-5
may be added to the V-9904M-5
for backbox protection
for use where extra speaker
support is needed. A V-9915M-5
may be added to the V-9904M-5
for backbox protection
NOTE: The V-9915M-5 cannot
be used in V-1010C installations
without the V-9904M-5.
be used in V-1010C installations
without the V-9904M-5.