Pyle pzr30xa 사용자 설명서

2 – PYLE PRO PZR6XA/10XA/30XA/50XA Amplifier Owner’s Manual

INSTALLATION GUIDELINES
Connecting the GND (GROUND) screw terminal Connecting

a mixer or preamplifier may cause excessive noise or hum

in the amplifier output. To prevent this, connect one end

of a low-capacitance shield wire to the amplifier's ground

screw (on the rear panel). Then connect the other end of

this wire to the ground terminal on the mixer or preamplifier

enclosure.

Input connections
These amplifiers accept a board range of input sources,

including Compact Disc (CD,DVD) players; Cassette, Reel-

to-Reel or other tape players; Radio Tuners; Equalizers;

Signal Processors.

Connecting a CD, DVD, tape player or tuner
In a normal installation, one would use the RCA JACKS for

connecting a CD player, DVD player,tape player or tuner.

Connecting an equalizer or external signal processor
Connect the processor's OUT to the amplifier's IN connector.

You can connect 4 Ohm, 8 Ohm or 16 Ohm speakers to

Channel 1 and/or Channel 2 of the amplifier. If you connect

two pairs of speakers, be sure to follow these guidelines:

• Speakers which are connected to the same channel are

part of a pair, and must be of the same impedance.

• Speakers connected to different channels are NOT part

of a pair, and can be of different impedances.

1.  Prepare the speaker wire by removing about 1 inch of

insulation from the end of the speaker wire you intend to

connect to the amplifier.  Then twist the exposed wire to

secure all the wire strands.

2.  Connect the speaker wires to the speaker's positive and

negative terminals.

3.  Connect the speaker wires to the amplifier's left and

right speaker terminals according to the terminal color

polarity.

Your Pyle Pro amplifier can be operated in Stereo, Mono or

Bridged mode, depending on the input source. If the input

signal is mono, slide the Stereo/Mono/Bridged selector

switch to MONO and the signal will be routed through both

channels. If you wish to run the amplifier in bridged output

mode, slide the switch to Bridged.

This amplifier can operate in a mono bridged output mode, if

your speakers can handle the following power output levels:

As shown in the diagram below, connect the speaker's positive

(+) to the amplifier's red speakers left (1/2) terminals and

negative (-) to red speakers right (1/2) terminals.

The speaker right (+) on the amplifier is used as a negative (-)

terminal for a bridged connection.

PYLE PRO PZR6XA/10XA/30XA/50XA Amplifier Owner’s Manual  – 3

HO

T(+)

COLD(

-)

GND(+)

BALANCED  INPUTS

HO

T(+)

COLD(

-)

GND(+)

BALANCED  INPUTS

HO

T(+)

COLD(

-)

GND(+)

BALANCED  INPUTS

HO

T(+)

COLD(

-)

GND(+)

BALANCED  INPUTS

HO

T(+)

COLD(

-)

GND(+)

BALANCED  INPUTS

HO

T(+)

COLD(

-)

GND(+)

BALANCED  INPUTS