Pyle pt110 사용자 가이드

THE VEHICLE USING FOR THIS POWER SOURCE MUST
HAVE A NEGATIVE GROUND ELECTRICAL SYSTEM. IF
YOU ARE NOT SURE OF IT, PLEASE CHECK WITH YOUR
VEHICLE'S DEALER.

Turning the amplifier on

1.Turn on the audio input source equipment

which is connected to the amplifier INPUT
jack.

2.Set all volume levels (MASTER, MIC 1, MIC 2, and

PHONO/AUX) to their minimum level settings.

3.Press the power switch to turn the amplifier on.
4.Adjust the controls of MIC 1, MIC 2, and PHONO/AUX

to the achieve desired volume and balance.

Using the LED power meter

The meter LED position indicate the amplifier
output power.

Using the MASTER volume control

The MASTER volume control increases or decreases
output level gain.
To obtain best performance with the least distortion,
be sure to adjust the output level so that the LED meter
does not continually
exceed the right extreme of the meter's range.
CAUTION:Setting output level too high can overdrive
the amplifier, causing permanent damage.

Using the MIX BUS jack

You can connect another PT110/PT210 to this
jack to double the size of your PA system. This
lets you use up to four microphones and two
turntables (or two auxiliaryies) sound souces.

Use a shield cable with phono plugs at each end, and
connect the cable between the MIX BUS jacks on the
back of two amplifiers.
For the best results, do not use a cable longer that 6
feet.

Specifications

Output Power at THD 10%, 1 kHz

.......................................

20W (PT110)/40W (PT210)

Maximum Power

.....................................

80W (PT110)/120W (PT210)

THD at 1W, 1 kHz Low-Pass Filter
   MIC 1...................................................................1%
   MIC 2...................................................................1%
   AUX/CD ..............................................................1%
   PHONO ...............................................................1%
Frequency Response (at 1W, +/- 3 dB)
   MIC 1.................................................80 Hz - 20 kHz
   MIC 2.................................................80 Hz - 20 kHz

AUX/CD ............................................80 Hz - 20 kHz

PHONO (RIAA 100 Hz/10 kHz)......+13 dB/-13.5 dB
Input Sensitivity (at 10% THD, 1kHz)

MIC 1 .............................................................2.5 mV

MIC 2 .............................................................2.5 mV

AUX/CD.........................................................150mV
PHONO...........................................................3.5mV

Signal-Noise Ratio (Input Shorted) with WTD

MIC 1................................................................60dB
MIC 2................................................................60dB
AUX/CD ...........................................................70dB
PHONO ............................................................60dB

Noise Level (Input Shorted)..............................0.75mV
Tone Control (PT110)

-15dB (High Cut at 10 kHz)

Equalizer Control Range (PT210)

100 Hz.......................................................+/- 10 dB
1 kHz .........................................................+/- 10 dB
8 kHz .........................................................+/- 10 dB

Power Requirement

120V AC, 60 Hz/240V AC, 50 Hz
4A 12V DC (OPTION OF PT110)

Power Fuse

120V AC ........................1.2A (PT110)/1.5A (PT210)
240V AC ......................0.6A (PT110)/0.75A (PT210)

Dimensions H x W x D,

3 1/3 x 12 3/4 x 8 9/10(inches)
85 x 324 x 226(mm)

Weight, (kg)

(PT110)3.56kgs/(PT210) 3.92 kgs