Pyle pla1085 사용자 가이드

blue wave

PLA485

2 channel amplifier

frequency response

power supply voltage

output power @ 14.4v DC, 1KHz

RMS Power @ 4 Ohms

RMS Power @ 2 Ohms

Maximum Power Output

input sensitivity

low level inputs

high level inputs

50 Watts x 2

80 Watts x 2

300 Watts x 2

15 Hz-30 KHz

250mV

2.5V

14.4V DC Neg. Ground (10.5-16V)

crossover mode selector

input level control

low pass frequency control

high pass frequency control

bass boost level control

low level inputs

high level inputs

power LED

protection LED

power fuse

power terminals

speaker connections

when used with normal, full range systems, set this switch to “FULL.” If

you wish to use the internal crossover to power a driver of specific frequency

range, use the “LOWPASS” or “HIGHPASS” settings.

use this control to match the outputs of your head unit to the amplifier.

Starting with your head unit set at about the 2 o’clock position, increase

the amp level control until distortion begins to occur, and reduce slightly

from this point.

when the crossover selector switch is in “low pass” mode, this control

sets the upper frequency limit for audio program sent to the speakers.

when the crossover selector switch is in “high pass” mode, this control

sets the lower frequency limit for audio program sent to the speakers.

this control permits adjustment of the bass level up to an increase of

approximately 18 dB.

this amp features gold-plated RCA input jacks for high impedance input.

Use these with car stereo output which uses RCA-type connector cables.

if your car stereo lacks RCA-type output jacks, you may connect speaker

output leads to these input connectors.

this indicator is illuminated when power is applied.

this indicator is illuminated when built-in protection circuitry is activated.

the fuse protects the amplifier and your car’s electrical system from short

circuit conditions.

use these connectors to deliver power, ground and remote turn-on control

to the amplifier.

these terminals are 14K gold plated to guarantee high conductivity and

minimum signal loss.

pla485

maximum current draw

dimensions (W x H x L)

inches

2-4 Ohms

15A

4-8 Ohms

input impedance

low level inputs

high level inputs

10K Ohms

100 Ohms

matching speaker impedance

stereo mode

bridged mode

features and

controls

2 c h a m p P L A 4 8 5

features and specifications